Premium fuel tank sealer and caliper paint online shopping? POR-15 Metal Prep provides the best adhesion for POR-15 Rust Preventive Coating on any metal surface, including aluminum and shiny polished metal surfaces. Our simple process gently etches metal, creating an ideal anchor pattern for coatings such as POR-15 Rust Preventive Coating, while simultaneously leaving a zinc phosphate coating to insure chemical bonding of paint and steel. Avoid other preps that may leave harmful residues which prevent proper adhesion. After thoroughly degreasing your work piece, apply environmentally safe POR-15 Metal Prep to both neutralize any rust and etch any clean bare metal. This will allow better adhesion of POR-15 Rust Preventive Coating or any other coating. POR-15 Metal Prep is not caustic, corrosive, toxic or flammable.
POR-15 Alloy Prep Soft Metal Etching Rust Neutralizer (formerly AP-120 Metal Prep) is designed exclusively for use with our 2K Urethane Clear, Alloy Prep guarantees perfect adhesion of 2K Urethane to any metal surface, especially chrome or polished aluminum, where good adhesion is often difficult to achieve and where other solutions may discolor. Alloy Prep is non-flammable with no noxious fumes. Wear rubber or latex gloves when using.
POR-15 Rust Remover will safely remove light to even heavy rust completely from metal surfaces and will not affect plastic, PVC, Viton, or most paints. One gallon derusts several hundred pounds of heavily rusted steel, this equates to around 1/2 to 3/4 pounds of dry rust removed per gallon. Rust Remover will not harm unrusted steel and is safe on other metals. Rust Remover has no fumes or bad odors and no VOCs. No sanding or scrubbing required. POR-15 Rust Remover works in as little as 20 minutes for light rust or overnight for heavy rusted metal. All of the rusted areas must be submerged in the Rust Remover for it to work. When all of the rust has been removed, rinse the metal pieces with water. POR-15 Rust Remover works in as little as 20 minutes for light rust or overnight for heavy rusted metal. For best results use POR-15 Cleaner Degreaser to clean parts before using POR-15 Rust Remover. Discover additional information on rust remover.
Remove all four wheels from vehicle. Calipers don’t need to be removed. Don’t remove brake line. Clean surfaces to be painted with POR-15 Cleaner Degreaser. Spray on the cleaner and brush the dirt, grease and grime with a small scrub brush or toothbrush. Wear protective gloves and glasses when cleaning your calipers. Read directions on POR-15 Cleaner Degreaser container before using. Rinse cleaned caliper thoroughly with water and dry with clean towel. Now apply POR-15 Metal Prep and keep surface wet for 20 minutes and then wash off POR-15 Metal Prep with water and dry thoroughly.
We make a product called ‘Metal-Ready’. It’s a rust remover that leaves a zinc phosphate coating on base metal, the perfect preprimer for POR-15. NOTE: New steel is coated with a protective oil finish at the mill. This finish must be removed before using POR-15 or Metal-Ready. Clean metal first with POR-15 Marine-Clean, then rinse with water and dry. Silver contains metal filler and should be used in badly rusted, pitted areas. It will fill in holes better than black or clear. Black is generally used on frames, underside of fenders, etc. because that’s the usual color there. Clear renders the smoothest finish and is often used as a preprimer on exterior surfaces; Gray is great on concrete floors, bilges, storage areas, as well as steel as desired. Read extra details on por15.com.