Weld nuts and weld studs are commonly used to provide a means for subsequent fastening of additional components and assemblies, or for periodic removal of service parts for maintenance and repair. When specifying welded fasteners, care should be taken not to tightly tolerance concentricity or perpendicularity to a datum plane, since this drastically increases cost. Weld fasteners located by holes punched by prior stamping operations are an accurate and generally preferred location method. For maximum cost-effectiveness, select weld nuts and studs of one size that will be used throughout the assembly. This helps to keep set-ups to a minimum and increases manufacturing throughput. Nuts located by holes are typically within ±0.006 (0.15 mm) of the original hole location. Studs can be located to ±0.020 (0.51 mm) with simple fixturing. Closer tolerances require more sophisticated and costly fixtures.

Position the welding torch with the wire in the center of the hole contacting the back sheet of metal. It is important to arc against this back sheet rather than on the edge of the hole, otherwise the weld might not penetrate into the back sheet. The torch should ideally be pointing directly into the hole rather than at the angle in the photograph. Start welding in this position and don’t move the welder until the hole is almost full of weld. Then move the welder outwards in ever increasing circles until the weld is completed.

Spot welding is a resistance welding process that is used primarily for welding two or more metal sheets together by applying pressure and heat to the weld area. It works by contacting copper alloy electrodes to the sheet surfaces, whereby pressure and electric current are applied and heat is generated by the passage of current through resistive materials such as low carbon steels. Read more info on https://www.weldingsuppliesdirect.co.uk/welding-equipment/spot-welding.html.

Stationary spot welders are mounted on a column with a jack and mobile arms. The frame is heavy and bulky and the machine has a welding capacity of 0.5–10mm. The body of the machine often equipped with a 380V generator and two arms with a mechanical, pneumatic or hydraulic jack to adjust operating height, as well as heat-resistant electrodes made of copper or copper-chromium alloy. No electric arc is produced, and the arms are water-cooled in closed circuit. The arms and electrodes are interchangeable to vary spot size and form across different types of weld.